|
Post by Admin on May 6, 2019 1:09:56 GMT
Hi Cobbie was wondering how the project is going? I created a trigger wheel with the M15A pattern per your measurements to try on my test car that originally has a distributor. Will let you know how it goes. Cheers, Matthew Attachments:
|
|
cobbie
New Member
Suzuki M15A Project Car
Posts: 10
|
Post by cobbie on Jun 26, 2020 3:24:55 GMT
Hello Mathew,
Its been too long, but I have the project back on the bench. I see things have changed with the Teensy 3.5 now I can do the VVT cam! Does it need some sort of adaptor to go where the Arduino went? Is the CAN bus out working? If not I have see how to do my dash separately. I must admit I have found it a bit daunting to get this all going but I see you have done my file and now with the VVT control available I am keen to push through. I am happy to document all this if we get things going if it helps others to. All the best Peter.
|
|
|
Post by Admin on Jun 29, 2020 9:32:54 GMT
Hi cobbie, No worries - all in good time :-) Yes the daughterboard accommodates the Teensy 3.5 and also adds a couple of drivers for VVT etc. Yes the CAN bus works right now is custom code for the GTI but I'm adding a general output for any CAN database. Only stumbling block is the code I have is for M15A batch fire just using the crank sensor. You'll need to scope the car (I can help if need be) to get the exact VVT range so I can add the trigger type... Cheers,
|
|