Total Noob Here, What Is Needed?

Hi mate there is a little bit of DIY work to do as far as buying the ECU enclosure (https://www.digikey.com/product-detail/en/hammond-manufacturing/1455N1602/HM980-ND/460179) and doing a little cutting of the end plate to accept the header plug.

For the wiring harness I sell the connectors and pins or connectors and terminated wires. You would need to be able to insert the wires into the connector (can tell you which pins) and splice them into your existing wiring harness. Can give you the part numbers also if you prefer to source yourself.

The ECU main board and terminated wires can be found here:

www.tindie.com/products/ECUMatt/rabbit-ecu-mixed-terminated-wire-40-pack/
www.tindie.com/products/ECUMatt/rabbit-ecu-v11-populated-pcb-kit/

As far as coding goes you don't need to change anything - you might have to give me some info on your engine so I can make any changes needed.

You need to grab an Arduino Due (I can sell you one or find one on ebay). You reprogram the latest updates over USB using wither Bossa or SAM-BA these are free programs you can download and are pretty easy to use.

Cheers

Matthew